Philips 32PF9968/10 Service Manual page 9

4.3.7 Small Signal Board (SSB)
Note: Depending on the model number, some models come
with a shielding around the SSB, others do not. Please refer to
the appropriate paragraph below.
SSB Shielding removal (when present)
1. Refer to next fig. "SSB Shielding".
2. Cautiously disconnect the LVDS cable [1] from the SSB.
3. Remove all other cables [2] from the SSB.
4. Remove the fixation screws [3] and remove the SSB
shielding with the SSB board inside and the rear
connector plate still attached to it.
5. Refer to fig. "Rear connector plate" below.
6. Remove the connector fixation screws [3] from the
connector plate and remove the metal connector plate from
the SSB board.
7. Remove the upper part of the shielding from the SSB
panel, by unhooking it from its brackets. Be careful not to
damage the LVDS connector on the SSB board.
1
3
Figure 4-10 SSB shielding
3
Figure 4-11 Rear connector plate
Mechanical Instructions
3
2
F_15420_038.eps
070605
3
F_15270_075.eps
260505
LC4.8L LA
SSB removal (if no shielding present)
1. Refer to earlier fig. "Rear connector plate".
2. Remove the connector fixation screws [3] from the
connector plate and remove the metal connector plate from
the SSB board.
3. Refer to next fig. "Small Signal Board".
4. Cautiously disconnect the cables [2] from the SSB.
5. Remove the fixation screws [1].
6. Remove the SSB panel.
2
Figure 4-12 Small Signal Board
4. EN 9
2
2
1
2
H_16980_046.eps
200207