Sharpness - Imi Tech Mx-xxxxG Series User's Operation Manual

AMAZON SERIES Operation Manual
4.3.

Sharpness

The sharpness control feature may be used to compensate low-pass effects caused, for instance, by the special
color interpolation. If you do not prefer such signal manipulation, you may switch it OFF. For sharpness control
inquiry and status register, follow the same definition as "BRIGHTNESS"
4.4. White Balance
Color models have the white balance feature which can be controlled automatically or manually. U/R(Red/Green)
and V/B (Green/Blue) alter the degree to which Red and Blue CCD component pixels are weighed to form composite
pixels. In manual mode you can adjust the white balance by altering the Blue (U/V) and Red Value (V/R). One
Push and Auto White Balance are supportable for Color models.
Inquiry Register
Address
F0F0050Ch
Status Control Register
Address
F0F0080Ch
P i o n e e r i n D i g i t a l V i s i o n T e c h n o l o g y
A_M_Mode
-
Value
Name Field
WHITE_B Presence_Inq
AL_INQ
Abs_Control_Inq
-
One_Push_Inq
ReadOut_Inq
ON/Off_Inq
Auto_Inq
Manual_Inq
Min_Value
Max_Value
Name Field
WHITE_B Presence_Inq
ALANCE
Abs_Control
Read: read a status
0: OFF, 1: ON
If this bit=0, other fields will be read only.
[7] Write: set the mode,
Read: read a current mode
0: Manual, 1: Auto
[8..19]
Reserved
[20..31] Value: Write the value in Auto mode, this filed is
ignored.
If "ReadOut" capability is not available, read value
Has no meaning
Bit Description
[0] Presence of this feature
[1] Capability of control with absolute value
[2] Reserved
[3] One push auto mode (Controlled automatically by
camera only once)
[4] Capability of reading the value of this feature
[5] Capability of switching this feature ON and OFF
[6] Auto mode (Controlled automatically by camera)
[7] Manual mode (Controlled by user)
[8..19] Minimum value for this feature control
[20..31] Maximum value for this feature control
Bit Description
[0] Presence of this feature. 0: N/A, 1: Available
[1] Absolute value control
0: Control with value in the Value field
1: Control with value in the Absolute value CSR
Page 41