Connecting To A Stereo System - Sony MZ-R700 Analog PCLink Operating Instructions Manual

Connecting to a stereo system

Connect the i jack of the recorder to the LINE IN jacks of an
amplifier or a tape recorder with a line cable (RK-G129 or RK-G136,
not supplied). The output is analog. The recorder plays the MD
digitally and sends analog signals to the externally connected
equipment.
to i
When the recorder is connected to an another
audio component through the supplied remote
control.
When connecting a line cable (not supplied) to the headphones/
earphones jack of the remote control, be sure to set the "BEEP"
setting to "BEEP OFF." This keeps the beep sound out of the
recorded signal or the output from the externally connected
equipment.
1
Press ENTER, press <MENU, repeatedly until "BEEP"
flashes in the display, and then press ENTER again.
2
Press <MENU, repeatedly until "BEEP OFF" flashes in the
display, and then press ENTER.
To turn on the beep sound
Select "BEEP ON" in step 2.
RK-G136
(not supplied)
RK-G129
(not supplied)
Stereo
mini-plug
Portable DAT
recorder, etc.
to LINE IN
R (red)
Stereo system,
etc.
L (white)
2 phono plugs
39