Sony MG110 Operating Instructions Manual page 13

The disc number* at the loading position
appears in the display. As you turn DISC
ACCESS, the disc number or Disc Memo
changes.
* If you have already loaded discs, the disc
number at the playing position appears. When
you turn DISC ACCESS, the displayed disc
number changes to the one at the loading
position.
Disc number
Total number of tracks and total playing time
3
Insert a disc with the label side facing
right.
Notes
• Make sure you have loaded the disc into each
slot at a right angle to the rotary table. If the
disc is not put in straight, it may damage the
unit or the disc.
• Make sure the rotary table comes to a complete
stop before loading or removing discs.
With the label
side facing
right
4
Repeat steps 2 and 3 to load additional
discs.
5
Close the front cover by pushing the
right edge of the cover until it clicks.
The rotary table turns and the disc slot at the
loading position is set to the playing
position.
Removing CDs
After following step 1 of "Loading a CD" on
page 12, remove the discs. Then close the front
cover.
Notes
• Always close the front cover except when you load
or remove discs.
• Do not load an empty 8 cm CD adaptor. It may
damage the unit.
• Do not attach anything such as seals or sleeves to
CDs. It may damage the unit or the disc.
• If you drop a disc into the unit and the CD will not
go into the slot correctly, consult your nearest Sony
dealer.
• When transporting the unit, remove all discs from
the unit.
• If you want to remove the disc played, open the
front cover. The disc comes to the loading position.
Remove the disc after the rotary table comes to a
complete stop.
Tip
You can display the original Disc Memos instead of
the disc numbers (see "Labeling a CD" on page 16) to
locate the disc easily when you start playing.
When you select a CD-TEXT disc, the disc title is
displayed instead of the disc number.
13