Timer-Recording Radio Programs - Sony MG110 Operating Instructions Manual

Timer-recording radio
programs
You can record a preset radio station from a
specified time.
To timer-record, you must first preset the radio
station (see "Presetting radio stations" on
page 18) and set the clock (see "Setting the
time" on page 11).
1
Tune in the preset radio station (see
"Listening to the radio" on page 19).
2
Press TIMER SET (or CLOCK/TIMER
SET on the remote for MHC-MG110).
3
Press – . or > + (or . or >
on the remote) repeatedly to select
"REC SET," then press ENTER.
"ON" appears and the hour indication
flashes.
4
Set the time to start recording.
Press – . or > + (or . or > on
the remote) repeatedly to set the hour, then
press ENTER.
The minute indication flashes.
Press – . or > + (or . or > on
the remote) repeatedly to set the minute,
then press ENTER.
5
Set the time to stop recording following
the procedure in step 4.
The start time appears, followed by the stop
time, the preset radio station to be recorded
(e.g., "TUNER FM 5"), then the original
display appears.
6
Load a recordable tape into deck B.
7
Press ?/1 to turn off the system.
When the recording starts, the volume is
reduced to minimum.
Other Operations
To Do this
Check the Press TIMER SELECT (or CLOCK/
setting TIMER SELECT on the remote for
MHC-MG110) and press – . or
> + (or . or > on the remote)
repeatedly to select "REC SELECT".
Then, press ENTER. To change the
setting, start over from step 1.
Cancel the Press TIMER SELECT (or CLOCK/
timer TIMER SELECT on the remote for
MHC-MG110) and press – . or
> + (or . or > on the remote)
repeatedly to select "TIMER OFF",
then press ENTER.
Notes
• If the system is on at the preset time, the recording
will not be made.
• When you use the Sleep Timer, Timer-recording
will not turn on the system until the Sleep Timer
turns it off.
23