Adjusting The Sound Characteristics; Attenuating The Sound; Changing The Sound And Display Settings - Sony MDX-C7900R Operating Instructions Manual

Adjusting the sound
characteristics
You can adjust the bass, treble, balance and
fader.
Each source can store the bass and treble levels
respectively.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n BAS (bass) n TRE
(treble) n BAL (left-right) n FAD (front-
rear)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting
the item. (After three seconds, the dial
functions as the volume control.)

Attenuating the sound

Press (ATT) on the rotary commander or
wireless remote.
"ATT on" flashes momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
The unit decreases the volume automatically when
a telephone call comes in (Telephone-ATT
function).
Changing the sound and
display settings
You can set:
• Clock (page 6).
• CT (Clock Time) (page 15).
• D.Info (Dual Information) to display the
clock and the play mode at the same time
(on) or to display the information alternately
(off).
• Amber/Green to change the illumination
colour to amber or green.
• Dimmer to change the brightness of the
display.
— Select "Auto" to dim the display only
when you turn the lights on.
— Select "on" to dim the display.
• Contrast to adjust the contrast if the
indications in the display are not
recognizable because of the unit's installed
position.
• Beep to turn on or off the beeps.
• RM (Rotary Commander) to change the
operative direction of the controls of the
rotary Commander.
— Select "norm" to use the rotary remote as
the factory-set position.
— Select "rev" when you mount the rotary
remote on the right side of the steering
column.
• A.Scrl (Auto Scroll) (page 7, 19).
1
Press (SHIFT).
2
Press (2) (SET UP) repeatedly until the
desired item appears.
Each time you press (2) (SET UP), the item
changes as follows:
Clock n CT n D.Info n Amber/Green n
Dimmer n Contrast n Beep n RM n A.Scrl
Note
The displayed item will differ depending on
the source.
3
Press (4) (n) to select the desired
setting (for example: ON or OFF).
4
Press (SHIFT).
After the mode setting is complete, the
display goes back to normal playback
mode.
EN
17