Additional Information; Precautions - Sony MDX-C7900R Operating Instructions Manual

Sony operating instructions fm/mw/lw minidisc player mdx-c7900r
Hide thumbs Also See for MDX-C7900R:
Table of Contents

Advertisement

Available languages

Available languages

Additional
Information

Precautions

• If your car was parked in direct sunlight
resulting in a considerable rise in
temperature inside the car, allow the unit to
cool off before operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• If no sound comes from the speakers of
two-speaker systems, set the fader control to
the centre position.
•If your car is equipped with a power aerial, it
will extend automatically while the unit is
operating.
If you have any questions or problems
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.
Moisture Condensation
On a rainy day or in a very damp area,
moisture may condense on the lenses inside
the MD player. Should this occur, the unit will
not operate properly. In this case, remove the
disc and wait for about an hour until the
moisture has evaporated.
Notes on MDs
Since an MD itself is housed in a cartridge, free
from accidental contact with your fingers and
dust, it can withstand a certain degree of the
rough handling. However, dirt or dust on the
surface of the cartridge or a warped cartridge
may cause a malfunction. Observe the
following for best results.
Never touch the surface of the MD itself by
deliberately opening the shutter on the
cartridge.
Do not expose the MD to direct sunlight or
heat sources such as hot air-ducts. Do not leave
it in a car parked in direct sunlight where there
can a considerable rise in temperature.
Make sure the MD is not left on the dashboard
or rear tray of a car. where the temperature can
also be excessive.
Notes on mounting labels
Be sure to mount labels on cartridges correctly,
as failing to do so may cause the MD to
become stuck in the changer.
•Mount the label in a suitable position.
•Remove old labels before putting new ones
on.
•Replace labels that are beginning to peel
away from the MD.
Cleaning
Wipe the surface of the MD cartridge from
time to time with a soft dry cloth.
EN
23

Advertisement

Table of Contents
loading

Table of Contents