Table of Contents
Advertisement
Setting special functions
In the state of on, press the key
finally press key
to confrim.If there is no key is pressed for 10 seconds,it will automatically exit and the previous
setting is invalid.
Child lock
Press the key
and
available.
ON/OFF
Press the key
to switch on /off the wired controller.
Forced to start pump (for debugging)
In the state of off, press the key
Checking parameters and change functions (for debugging)
When the backlight is on, press the key
available under the status of on or off.
(Some functions reserved, if the relevant device is not connected in the system, the relevant function code and
machine number will not participate in the loop.)
(1) Press the key
or
unit-- reserved)/ D (Module control board-- reserved)/ E (slave wired controller -- reserved).
(2) A/B is displayed after the decimal point in the intemedidate temperature display area,function code(00-FF) is
displayed in the lower right corner.00-3F can be viewed and changed,while 40-FF can only be queried.The specific
parameters are displayed in the upper right corner.
(3) Switch the function code by using the
queried and can be changed.And if the function code is still,which means that it can only be queried. When the
function code is flashing, press the
to indicate that it can be changed. You can adjust the value by the
key again and the parameter value will not flash. And the function code flashes, indicating that the previous layer
operation is returned. If there is no operation for over 10 seconds, or press the SET key in the state of viewing the
parameter (when function code is 40-7F), exit the parameter viewing and setting interface. And you can also exit
this interface by pressing on/off key.
, then swich among ECO ,QUIET and TURBO by pressing
for 10 seconds to set or cancel child lock. In the state of child lock, all keys are not
for 15 seconds to enter and press the key
and
for 5 seconds to enter into this function's interface , which is
to switch the function code, category A (Heat exchange unit)/ B (outdoor unit)/ C (indoor
or
key. If the fuction code is flashing,which means that it can be
key to make the function code still. Meanwhile, the parameter value flashes
for 15 seconds again to exit.
or
key. After adjustment, press the
65
or
key,
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AU082FYCRA(HW) and is the answer not in the manual?