Operation procedure
Preparation:
Prepare a USB Memory to export data stored in this unit.
Create the following directory on the USB Memory.
EEPBAKUP
Boot:
1. On Tuner Service Mode display
Using Remote Control, move the cursor to user's setting information backup display position (Refer to below) on Tuner
Service Mode display.
2. Press [OK].
After "Try OK" is displayed, the data is exported to USB Memory.
(Refer to below)
When OK(***) is displayed, the data is successfully exported.
Note:
If the backup file already exists in the USB Memory, the data is overwritten and "OK" is displayed.
3. Remove the USB Memory from the unit.
4. Turn the unit OFF to finish Tuner Service Mode.
Restoring the backup data to the unit
1. Turn the unit ON.
Perform the following: FUNCTION MENU SETUP BASIC SETTINGS OTHERS INITIALIZE SHIPPING
CONDITION
2. Start Tuner Service Mode.
3. Insert the USB Memory in save data to the unit.
4. Using Remote Control, move the cursor to user's setting information backup display position (Refer to below) on Tuner
Service Mode display.
5. Press [ENTER].
After "Try OK" is displayed, the data is restored to USB Memory.
(Refer to below)
When OK(***) is displayed, the data is successfully exported.
6. Remove the USB Memory from the unit.
7. Turn the unit OFF to finish Tuner Service Mode.
32