FlashPoint Zoom Mini Manual page 15

C.Fn: Setting Custom Functions
The following table lists the available and unavailable custom functions of this flash.
Custom
Function Signs
ST
AF
BL
AP
< ZOOM >
1. Press the
2. Turn the Select Dial to select the Custom Functions.
3. Press the <SET>
4. Turn the Select Dial to set the desired number. Pressing the
will confirm the settings.
5. Press the <ZOOM>
Note: When attaching to the camera, the auto focus assist
beam of the Zoom Mini can only be triggered by setting
its focus mode (M/C/S) to S mode. The other two modes
cannot light up the auto focus assist beam.
Center effective range is
range is
2-8.2ft / 0.6-2.5m
Using the Wide Panel
Pull out the wide panel and place it over the
flash head as shown. The flash coverage will
then be extended to 14 mm.
• The catchlight panel will come out at the
same time. Push the catchlight panel back in.
The <ZOOM> button will not work
Low Battery Warning
If the battery power is low, < > will appear
and blink on the LCD panel. Please replace the
battery immediately. When the low battery
indicator is displayed, the ZOOM can not be
adjusted, it will constantly be 24mm.
Function
Auto sleep
(standby)
AF-assist beam
Backlighting
control
ZOOM display
format
Button for 2 seconds until C.Fn menu is displayed.
Button and the Setting No. blinks.
Button to exit.
2-13ft / 0.6-4m
.
Setting No.
ON
OF
ON
OF
10 Sec.
OF
ON
ON
OFF
, and the periphery
Settings &
Description
ON
OFF
ON
OFF
Off in 10 sec.
Always off
Always lighting
APS
135
<SET> Button
15