Table of Contents
Advertisement
53
NSTAL LNG SEWNG HEAD N PORTASLE CASE
Please read these important instructions which were written to aid you in
placing your new sewing machines
in its portable case.
First, remove the foot control which
is
fastened inside the base to avoid
damage in shipping.
After
unpacking
the
sewing
machine
unit, being
certain
to
take
out
the Instruction book, guarantee and accessory box,
lay the unit face down on a table.
You will see two clamping screws A
entering head hinge holes B on the underside of the back.
On the base you will find two head hinges C which will fit
Into holes B.
Lower
the
base
onto
the
sewing
machine
fitting
hinges
C
into holes
B.
Tighten screws A securely with a screw driver.
-
To make the electrical connection draw the two wires through the slot in the
partition of the base. Plug the cord labeled "Motor" into the receptacle marked
"Motor" on the block
attached to the outer section of the base.
Then insert the other cord into the "Light" receptacle.
Place the foot control on the floor, insert plug into a wall outlet
(110-115
volts) and
you
are
ready
to
sew.
But
first
read
the
instruction book to
become familiar with the threading of the machine, tension adjustments
and
all the other features designed to make sewing a pleasure.
See Fig. 96 and 97 (R54)
Advertisement
Table of Contents
