Electro-Harmonix Epitome Manual page 3

HOLY GRAIL PLUS SECTION
REVERB Switch - Chooses the reverb mode. From top to bottom, the modes
are SPRING, HALL, ROOM and FLERB. When Shimmer is enabled, FLERB mode
changes to an echo effect. See Page 6 for descriptions of each reverb mode.
AMOUNT Knob - The function of the AMOUNT knob changes with each REVERB
mode:
BLEND Knob - Controls the wet/dry mix from 100% Dry (counter-clockwise
position) to 100% Wet (clockwise position). Set BLEND to 12 o'clock for an equal
mix of both.
SHIMMER Switch - Enables SHIMMER mode, which changes the routing
between each effect to produce a lush, shimmering reverb tone while keeping a
dry initial attack. See pages 4-5 for details on SHIMMER mode. When SHIMMER
mode is enabled, the Holy Grail Plus LED lights up green. If SHIMMER is
disabled, the Holy Grail Plus LED will be red.
FOOTSWITCHES & LEDs
Each effect section of the Epitome has its own independent footswitch to toggle
the associated effect in and out of bypass. Bypass through the Epitome is
buffered bypass.
MICRO POG Footswitch and STATUS LED – The footswitch located nearest
to the IN jack toggles the Micro POG effect on or off. When the LED in the Micro
POG section is lit, the Micro POG effect is active. When the Micro POG LED is off,
the Micro POG section is bypassed.
STEREO ELECTRIC MISTRESS Footswitch and STATUS LED – The
footswitch located in the middle of the Epitome toggles the Stereo Electric
Mistress effect on or off. When the LED in the Stereo Electric Mistress section is
lit, the Stereo Electric Mistress effect is active. When the Stereo Electric Mistress
LED is off, the Stereo Electric Mistress section is bypassed. When lit, the Stereo
Electric Mistress LED fades between red and green to show the rate of
modulation.
HOLY GRAIL PLUS Footswitch and STATUS LED – The footswitch located
nearest the OUT jack of the Epitome toggles the Holy Grail Plus effect on or off.
REVERB Mode
SPRING
HALL
ROOM
FLERB/Echo
AMOUNT Parameter
Reverb Time & Spring Time
Reverb Time
Damping Amount
Modulation Rate/Delay Time
3