Datamatrix Code - Siemens SIRIUS 3RT2 Manual

1.7

DataMatrix code

A DataMatrix code is lasered on the front of all units of the function modules, on the left on
the basic module.
In the case of basic and coupling modules, there is a further DataMatrix code behind the
labeling plate.
DataMatrix codes are standardized in ISO/IEC 16022. The DataMatrix codes on Siemens
devices use ECC200 coding for powerful error correction.
The following device information is encoded in the front DataMatrix code as a bit stream:
● Article number
● Serial number (abbreviated)
This information is stored in the following format in the DataMatrix code:
The following device information is encoded in the front DataMatrix code behind the labeling
plate as a bit stream:
● Article number
● Serial number
● Where appropriate, MAC address
This information is stored in the following format in the DataMatrix code:
The following device information is encoded in the side rating plate as a bit stream:
● Article number
● Serial number
● Where appropriate, MAC address
This information is stored in the following format in the DataMatrix code:
Note
The information content is displayed without spaces.
SIRIUS 3RA28 function modules for mounting on 3RT2 contactors
Manual, 02/2019, A5E03656507620A/RS-AD/005
1P
Data identifier
1P
Data identifier
1P
Data identifier
Article number
Net content
Article number
Net content
Article number
Net content
1.7 DataMatrix code
+
Separator Serial number
+
Separator Serial number
(+ 23S MAC address)
+
Separator Serial number
(+ 23S MAC address)
Introduction
S
S
S
9