Electrical Connections; Installation Wiring Diagram - 115Vac 2-Wire Pumps Up To 16 Fla - Pearl PCBC16F16S Owner's Manual

Electrical connections should made by a qualified professional in compliance with
applicable local codes and National Electric Code.
ALWAYS SHUT OFF POWER FOR INSTALLATION OR SERVICE.
Check voltage of pump and supply to determine pump motor FLA and follow applicable
BEST CONTROL wiring diagram. If pump motor FLA exceeds BEST CONTROL rating, use
magnetic starter wiring diagram for the applicable voltage ( see pages 12, 13).
Always remove pressure switch from surface pump and wire BEST CONTROL
directly to pump.
Use Copper Conductors only.
Use 140 / 167 ˚F wire.
Use minimum 13 AWG wire.
Device must be properly grounded.

INSTALLATION WIRING DIAGRAM - 115VAC 2-WIRE PUMPS UP TO 16 FLA

ELECTRICAL CONNECTIONS

OBSERVE WARNINGS AND PRECAUTIONS LISTED AT THE FRONT
OF THIS MANUAL.
- 9 -