Applying Effects To Output Audio; Correcting A Time Difference Between Video And Audio; (Delay) - Roland VR-1HD Reference Manual

Audio Operations

Applying Effects to Output Audio

Here's how to modify the tonal character by applying effects to the
audio output.
1
[MENU] button 0 "AUDIO OUTPUT" 0 "MAIN BUS" or
"AUX BUS" 0 select an effect menu item.
* For details on the effects, refer to the following section.
2
Turn the [VALUE] knob to edit the value of the setting,
and press to confirm.
3
Press the [MENU] button several times to close the menu.
Limiter (LIMITER)
Compresses the audio so that the mixed audio does not exceed the
specified threshold level.
* Distortion will occur if audio that exceeds the allowable range of
the limiter is input.
Menu item Explanation
LIMITER Turns the limiter on/off.
LIMITER
Specifies the threshold at which the limiter applies.
THRESHOLD
Equalizer (EQ)
Adjusts the tone quality for each frequency band.
Menu item Explanation
EQ Press the [VALUE] knob to access the EQ (equalizer) menu.
SW Turns the equalizer on/off.
HI Boosts or attenuates the high band.
Adjusts the center frequency when changing the tone
HI FREQ
quality in the high band.
MID
Boosts or attenuates the middle band.
Adjusts the center frequency when changing the tone
MID FREQ
quality in the middle band.
Adjusts the width of the frequency band when boosting
MID Q
or attenuating the middle band.
LO Boosts or attenuates the low band.
Adjusts the center frequency when changing the tone
LO FREQ
quality in the low band.
20
Correcting a Time Difference Between
Video and Audio (Delay)
If there is a timing discrepancy between the video and audio, you can
correct the output timing by delaying the audio output.
1
[MENU] button 0 "AUDIO INPUT" 0 "MIC 1"–"USB FROM
PC" 0 select "DELAY."
2
Turn the [VALUE] knob to adjust the delay time of the
input audio, and press to confirm.
3
Press the [MENU] button several times to close the menu.
MEMO
For the USB STREAM port and AUX bus (p. 24), you can adjust the
delay time of the audio output.
Press the [MENU] button 0 "AUDIO OUTPUT" 0 "USB STREAM"
or "AUX BUS" 0 and adjust "DELAY. "