Bissell 2503 Series User Manual page 9

Cleaning the Brush Roll
WARNING
To reduce the risk of electric shock, turn Power Switch OFF and disconnect plug from electrical outlet
before performing maintenance or troubleshooting checks.
1
Pinch the tabs on the Brush Guard
inward and pull to remove.
3
Clean the Brush Roll
with the Cleaning Tool.
Cleaning the Sensors
2
Lift to remove the Brush Roll.
4
Replace the Brush Roll and Brush Guard.
NOTE: The Brush Roll has two different end pieces.
Ensure the square-shaped end piece is inserted into
the square-shaped port.
After repeated use, debris can
accumulate on the sensors of the
robot and the working efficiency can
be reduced.
To ensure the best efficiency, the
sensors should be cleaned off
periodically by brushing any debris
from them.
Before cleaning the sensors, ensure
the Power Switch on the robot is in
the OFF (0) position.
www.BISSELL.com
9