Fault Messages And Fault Diagnosis - Ten-Haaft SunMover Operating Instructions Manual

Fault messages and fault diagnosis

After connection of the supply voltage the system performs a self-test. Apart from
various internal functions, this test also checks the ambient conditions.
A list of possible error messages and their causes can be found in the table below.
E
Message
GPS failure
Compass failure
EEPROM failure
Cause
The GPS receiver has not yet been recognised. Please wait a few se-
conds. If the message does not vanish then there is an electric fault in
the system.
Either there is an extremely powerful magnetic fi eld that is causing
interference (e.g. from large, unshielded speakers), or the system has
detected an electric fault on the compass. This may sometimes be reme-
died by a calibration.
This indicates an internal fault – the system needs to be returned to our
Customer Service department.
48