Important Notes - Ten-Haaft SunMover Operating Instructions Manual

Important notes

In order to ensure that your SunMover® works properly, you must ensure
that it is correctly connected to the ignition of your vehicle (see Installati-
on Instructions).
When it is correctly installed, the solar panel automatically assumes the rest positi-
on when the ignition is switched on and locks itself there. If the system cannot fully
retract or cannot retract at all due to a fault, then it is your responsibility as the
driver of the vehicle to check that the solar panel is safely and properly stowed.
The driver of the vehicle must inspect the external unit before driving off
to ensure that the external unit is fully retracted.
Please note also that different legal requirements apply to the operation of electri-
cal and electronic equipment in different countries. As the user of this equipment,
you yourself are responsible for ensuring compliance with the relevant laws and
regulations.
Your SunMover® has only been approved by the manufacturer for connection to
standard commercially available rechargeable lead batteries with a rated voltage
of 12 V (6 cells) and a rated capacity of at least 50 Ah. Connection to any other
type of battery system can lead to irreparable damage to the battery system or the
SunMover®, or to the release of fl ammable or toxic gases or to auto-ignition of the
unsuitable battery system.
The manufacturer accepts no liability for direct or indirect damage or
for consequential damage to the system itself, to battery systems, motor
vehicles or other equipment or goods resulting from the connection of
unsuitable battery systems or installation/wiring errors.
31
E