Porsche 911 Speaker Operating Manual page 9

Party mode
To swap from stereo mode to party mode, press the Bluetooth
®
the message 'Party mode'. Now press the Bluetooth button on 911 Speaker 2 multiple times for around three seconds, until you hear the message
®
'Party mode'. Both your 911 Speakers are now in party mode.
To set both 911 Speakers to party mode straight away, proceed as follows:
1. Switch on both 911 Speakers using the Power button .
2. Select the Bluetooth input [ the LED flashes or illuminates in blue ] for 911 Speaker 1.
®
3. Simultaneously press on 911 Speaker 1's Bluetooth and volume buttons
®
'True Wireless pairing'.
4. The left-hand LED of the 911 Speaker 1 will flash in blue.
5. 911 Speaker 1 will emit an acoustic signal every five seconds.
6. Select the Bluetooth input [ the LED flashes or illuminates continuously in blue ] for 911 Speaker 2.
®
7. Simultaneously press on 911 Speaker 2's Bluetooth ® and volume buttons
'True Wireless pairing'.
8. 911 Speaker 2's right-hand LED, located above the keypad, will flash in blue.
9. When you hear the message 'Stereo mode left' from 911 Speaker 1 and 'Stereo mode right' from 911 Speaker 2, and when the
flashing LEDs above the keypads of 911 Speakers 1 and 2 light up continuously, the connection has been established.
10. Press the Bluetooth button on 911 Speaker 1 multiple times for around three seconds, until you hear the message 'Party mode'.
®
11. Press the Bluetooth button on 911 Speaker 2 multiple times for around three seconds, until you hear the message 'Party mode'.
®
Betriebsanleitung_911_Speaker_420x148mm_EN.indd 16-17
button on 911 Speaker 1 multiple times for around three seconds, until you hear
for a short time; you will hear the message
for a short time; you will then hear the message
Please note: The devices will automatically save the last True Wireless status; this status can only be deleted by simultaneously pressing the
Bluetooth ® and Mute buttons . If the last True Wireless status remains saved, the devices will automatically link up the next time they are
switched on, provided they are within reach of each other.
AUX-IN True Wireless
The AUX-IN port can be used in True Wireless mode. For this, the AUX-IN port on the 911 Speaker to which the 3.5-mm audio jack cable is connected must
be selected. The second 911 Speaker remains set to Bluetooth input.
®
[ EN ] The 911 Speaker
16 | 17
15.08.17 09:13