Bullet tools Magnum 526 Quick Start Manual

Quick Start Guide
for Magnum Shear Model #526
In the Box:
(1) Power Assembly (1) Tail
(1) Handle Assembly (4) Rails
(1) Angle Guide (1) Hone Stone
(1) Table (1) Hardware Kit
ASSEMBLING YOUR SHEAR
Tools needed: #2 & #3 Phillips head screwdrivers, 1/2" socket or wrench.
• IMPORTANT •
Start all screws BY HAND
when assembling your shear.
This will help avoid cross-threading.
1. ATTACH RAILS
Attach rails to Power Assembly base using
Item A screws.
1
Power Assembly
SET UP
3. ATTACH TABLE
A. Attach front of table to base,
using Item C screws. Tighten
with #3 Phillips.
B. Attach back of table to tail using
Item D self tapping screws.
Tighten with #2 Phillips.
Item A. (8) #14 x 3" Self-Tapping Screws
Item B. (8) 6mm x 25mm PH Phillips Machine Screws
Item C. (6) M6 x 16mm FH Phillips Machine Screws
Item D. (4) #10 x 1 FH Phillips Self Tapping Screws
The Hardware Kit is used in multiple models. Your Shear may not use all of the items listed.
3
Item C
In the Hardware Kit:
Item E. (2) M8 x 50mm Hex Bolts
Item F. (1) M6 Thumbscrew (installed)
Avoid cross-threading by using
your fingers to start all screws
2. ATTACH TAIL
Attach tail to rails using Item C screws.
Make sure holes in tail are facing up.
2
3A
Tail
3B
Item D
Tail