Table of Contents
Advertisement
DSP functions
Problem
No sound, or sound is too low.
Error displays (when optional CD/MD changer is connected)
The following indications will flash for about five seconds, and an alarm sound will be heard.
Display
Cause
The disc magazine is not inserted in
NO MAG
the CD/MD changer.
No disc is inserted in the CD/MD
NO DISC
changer.
A CD/MD cannot play because of
NG DISCS
some problem.
A CD is dirty or inserted upside
down.*
ERROR
1
*
An MD does not play because of some
problem.*
No tracks have been recorded on an
1
*
BLANK
MD.*
The CD/MD changer cannot be
RESET
operated because of some problem.
The lid of the MD changer is open or
NO READY
MDs are not inserted properly.
The ambient temperature is more than
HI TEMP
50° C (122° F).
1
When an error occurs during playback of an MD or CD, the disc number of the MD or CD does not appear in the display.
*
2
The disc number causing the error appears in the display.
*
If the above-mentioned solutions do not help improve the situation, consult your nearest Sony
dealer.
Cause/Solution
The volume of the rear speakers may have been automatically
lowered in order to maximize the effect of the listening position
adjustment.
n Press (+) to adjust the balance.
The speaker balance can be set separately for the DSP on
mode and DSP off mode (page 15).
2
2
2
Solution
Insert the disc magazine with discs
into the CD/MD changer.
Insert discs in the CD/MD changer.
Insert another CD/MD.
Clean or insert the CD correctly.
Insert another MD.
Play an MD with tracks recorded on
it.
Press the reset button of the this unit.
Close the lid or inserted the MDs
properly.
Wait until the temperature goes down
below 50° C (122° F).
EN
27
Advertisement
Table of Contents
