Table of Contents
Advertisement
Quick Links
NVR Quick Start Guide
READ ME
FIRST!
Welcome! Lets get started.
To start using your NVR, you need the following:
1) A high-definition TV capable of displaying 720p
or 1080p video. Look at the ports on the back of
your TV to make sure it has an HDMI input.
2) A router with a broadband Internet connec-
tion.
3) A mobile device (Android or iOS) to download
the free SwannView Link app.
Carefully unpack each item and discard any
packaging not required.
QHGUAEYE040416E | © Swann 2016
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Swann NVR
Summary of Contents for Swann NVR
- Page 1 READ ME FIRST! Welcome! Lets get started. To start using your NVR, you need the following: 1) A high-definition TV capable of displaying 720p or 1080p video. Look at the ports on the back of your TV to make sure it has an HDMI input.
- Page 2 Getting to know your NVR Congratulations on the purchase of your Swann NVR. This Quick Start Guide will assist you on getting your NVR up and running as soon as possible. To make sure nothing was damaged during shipping, we recommend that you connect everything and give it a try before you do a permanent installation.
- Page 3 These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment 2) Ethernet Port: Connect this to your router so your NVR generates, uses and can radiate radio frequency energy and, if not can connect to the Internet (required for AP mode).
- Page 4 Step One: Installing the Antennas 1 2 V Located at the rear of your NVR are two antenna sockets. a firm connection to fasten (tools should not be required). There is also a single antenna socket at the rear of each Leave the antennas in a vertical position for best reception.
- Page 5 10 camera provided. seconds then release. Your camera will disconnect from your NVR momentarily and then reconnect. Connect the Power Input on the Power Cable to the Ethernet Port: Power Adapter. Repeat this step for each Power Adapter This port can be used to configure your provided.
- Page 6 Step Three: Connect to your Home Network Connect the supplied Ethernet cable to the Ethernet port (1) on your NVR then connect the other end to a spare port (2) on your router. Don’t proceed to the next step until this is done.
- Page 7 Step Four: Connect your Mouse Connect the supplied mouse (1) to the bottom USB port (2). To copy your video recordings and to perform a firmware upgrade, connect a storage device such as a USB flash drive (not included) to the top port. AUDIO DC 12V IN Please note:...
- Page 8 Connect the supplied HDMI cable to the HDMI port (1) on your NVR then connect the other end to a spare HDMI input (2) on your TV. The labels on the back of your TV indicate which input you need to select when your NVR is turned on.
- Page 9 Step Six: Connect your Power Adapter Connect the supplied power adapter’s power connection (1) to the power input (2) on your NVR first (this will minimise sparking). Connect the power adapter to a power outlet then press the outlet’s switch to the on position to supply power.
Need help?
Do you have a question about the NVR and is the answer not in the manual?
Questions and answers