Page 1
Invacare® OptiCharge 24 V 8 A/10 A en Lead Acid Battery Charger User Manual This manual MUST be given to the user of the product. BEFORE using this product, read this manual and save for future reference.
Page 2
All rights reserved. Republication, duplication or modification in whole or in part is prohibited without prior written permission from Invacare. Trademarks are identified by ™ and ®. All trademarks are owned by or licensed to Invacare Corporation or its subsidiaries unless otherwise noted.
We provide a manufacturer’s warranty for the product product safety notices and product recalls, contact your in accordance with our General Terms and Conditions of Invacare representative. See addresses at the end of this Business in the respective countries. document.
(e.g. WEEE and RoHS directives). • We only use REACH compliant materials and components. For further information, contact Invacare in your country (for addresses, see back page of this manual). 1.5 Intended use This Invacare off-board battery charger is intended to be used indoors with a 220–240 V AC / 50–60 Hz mains supply...
Page 6
Invacare® OptiCharge Pos. Designation Qty. Battery charger 8 A fitted with Europlug (CEE 7/16) Vari- Battery charger 10 A fitted with ants: Europlug (CEE 7/16) Battery charger 8 A fitted with UK plug (BS 1363) Battery charger 10 A fitted with UK...
– Only use the charger indoors. Invacare product manuals are available on the – Do not mount the battery charger directly onto internet or at your local provider (addresses are a mobility device.
Page 8
Invacare® OptiCharge WARNING! WARNING! – Users and suppliers of Assistive Mobility Risk of short circuit and electric shock if the products should give consideration to the battery charger has been damaged possibility of a failure to operate, or an – Do not use the battery charger if it has been incorrect operation, by the product.
Safety 2.2 Labels and symbols on the product Power indication Identification label Current indication The identification label is located on the backside Permitted types of batteries of the product. Manufacturer Warning symbol Identification label of 8 A charger shown as an example.
Invacare® OptiCharge Installing To Table 3 Setup • Centre punch 3.1 Installing Battery Charger • (Cordless) screwdriver, 5 mm drill bit, 5 mm Phillips screw insert The battery charger can be placed on its rubber feet on a • Drilling template (See end of this document) horizontal surface or be mounted to the floor or to the wall.
Page 11
Setup 1. Place the drilling template H on the table and hold it 1. Using a centre punch, mark the two drill holes at the in place. wall where you want to mount the charger. 2. Using a centre punch, mark the two drill holes indicated The distance between the two holes must be 120 by the template.
Invacare® OptiCharge 4 Usage WARNING! – Use only with a 220 - 240 V AC / 50 - 60 Hz mains supply. 4.1 Safety information WARNING! WARNING! – Circuit breaker or fuse protection in the AC – Keep charger protected from rain and moisture.
Usage 4.2 Using The Battery Charger 3. Connect the mains lead A to a suitable power socket. Battery level indicator LEDs D/E/F flash once. CAUTION! Power LED C illuminates green. Risk of injury from hot surfaces This indicates that battery is correctly connected and The XLR plug can become very hot during is charging.
Page 14
Invacare® OptiCharge • Check for correct connection • Contact your local provider 1636951-C...
Technical Data 5 Technical Data Approved battery capacity -capacity) 30 Ah – 80 Ah range at 8 A -capacity) 26 Ah – 68 Ah 5.1 General data Approved battery capacity -capacity) 30 Ah – 100 range at 10 A Electrical data Output current 8 A / 10 A ±...
Invacare® OptiCharge Product weight 1.4 kg Housing material PC / ABS If in doubt, contact your provider or supplier. 5.2 Environmental Parameters Operating conditions Ambient temperature -5 °C – +40 °C Relative humidity 10 % – 90 %, non-condensing Storage and shipping conditions Ambient temperature -40 °C –...
Need help?
Do you have a question about the OptiCharge and is the answer not in the manual?
Questions and answers