Table of Contents
Advertisement
10
Siemens Building Technologies
Cerberus Division
4
Functions and configurations
4.1
SLT configuration and transfer software
The test set is delivered from the factory with default templates for the measurement of
telecommunication lines. In order to be able to automatically measure Cerberus-
specific data transmission circuits, the following steps must be carried out once before
it is used for the first time.
Installation of the SLT configuration and transfer software on a service PC
Transfer of the specific template to SLT-22.
An Intel-based PC or Laptop with a spare RS232 interface is required for the SLT con-
figuration and transfer software.
Connect SLT-11/SLT-22 to the PC
Installing software
The software must be installed on the PC using the disk supplied.
1. Start the program with "setup.exe".
2. Follow the program instructions
Start software
Start in the program group ACTERNA (Wandel Goltermann) on the entry "SLT Sub-
scriber Line Tester"
The "Subscriber Line Tester" window is opened.
Transmission of the Cerberus templates
Download a Template set ...
Edit a Templates set ...
Upload Results ...
Viewing Results ...
e3180a.doc
12.2000
Advertisement
Table of Contents
