Quick Start - TAWI PRO40 User Manual

2 Quick start

This chapter presents how to fasten tools and how to start the lifter.
Fasten tools on the sleigh
Sometimes tools are attached at delivery. If not, at-
tach the tool to the sleigh with at least three screws.
Select which holes to use in order to get the desired
max and min lifting heights.
1. Align the selected holes for attachment on the
tool with the ones on the sleigh.
2. Fasten with at least three screws.
• Make sure the screws are fastened correctly
and that the correct torque is applied on
each screw.
• Make sure the screws are dimensioned to
carry the weight of the tool plus the max load.
• When fastening EasySqueeze arms, use four
screws (type M8) per arm.
Lift the lifter
To transport the lifter by lifting it, fasten a sling in the
handle according to illustration and lift.
6
Torques to apply
Tool attachment for
model
PRO 40 and PRO80
PRO140 and PRO180
PRO250
Type Torque (Nm,
class 8.8) (ft/lb)
M6 10 Nm
(7.3 ft/lb)
M8 24 Nm
(17.7 ft/lb)
M10 47 Nm
(34.6 ft/lb)