TAWI PRO40 User Manual page 11

Adjust legs
This section only applies to PRO80 and PRO140. The legs of these models can be adjusted in width.
Always apply brakes and take out the battery pack before leaning the lifter. Also make sure that no cables are
in the way or squeezed between the operator handle and the floor.
1. Lean the lifter and place it on its back.
2. Adjust the legs one side at a time:
a. Loosen and remove the screw closest to the
mast.
b. Loosen, but do not remove, the other screw
(located farthest away from the mast).
c. Refit the removed screw into the middle posi-
tion to enable the leg to move inwards and
outwards.
d. Extend the leg to desired position, make sure
it ends up within the max and min markings.
e. Remove the screw from the middle position.
f. Put the screw back and fasten into its original
position.
g. Make sure both screws are tightened to
24Nm (17.7 ft/lb).
3. Repeat step (2) for the other leg.
• Always adjust the legs within the max and min
markings.
• Exceeding this may cause damage to the lifter
and may cause injuries.
• The legs do not have to be adjusted
symmetrically.
• Each leg is adjustable by 150mm (5.9in).
24Nm
17.7 ft/lb
11