Comfort audio DT10 Technical Bulletin

Device: Receiver DT10
Subject: How to connect a Reciever DT10 to Phonak ComPilot
Status: Informational
This bulletin will briefly describe how to fit The Receiver DT10 to the Phonak ComPilot.

What is ComPilot?

The ComPilot is Phonak´s newest audio streamer that was launched during
the autumn this year.
It offers the possibility of direct connection for DT10 via its
Europlug.
A

Before The Fitting

Before any attempt to use the Receiver DT10 with the ComPilot please,
ensure that you have read through the following steps listed below in this
bulletin.
Step 1 Check Connection between The ComPilot and The hearing
aid
In order to find out whether the ComPilot has been selected, as
an accessory for the intended hearing aid, or not, you manually
have to read the settings of the hearing aid in the Phonak´s
Fitting Software Target 2.0.
Connect the Hearing aid to the Programming Interface and Start
the Target 2.0. Click on
reading the settings of the hearing aid by pressing
Button.
Please check if C the ComPilot is selected as an accessory for the
hearing aid in this menu.
If the Compilot is not selected as shown in
right Select it by pressing
Save the new settings into the hearing aid and disconnect it from
the programming interface.
For further information about saving the settings in Target 2.0, please read the
.
user manual for this software
Page1
the tab Hearing Instruments and start
A
D
the picture to the
E
the "+"button.
B
the Connect
C
D
Technical Bulletin
No: DT10-04
Date: 2011-12-09
Pages: 2
A
A
B
E