Advantek Networks AWR-11N-RT User Manual page 52

All manuals and user guides at all-guides.com
Ethernet port to be disabled while in repeater mode.
(4) Lazy – Automatic detection of WDS peers: when a LAN user searches for a network, AP
router will attempt to connect to WDS devices in its vicinity.
WDS Encryption Type:
(1) When the Authentication Mode is set as Open, Shared, or
WDS encryption type.
(2) When the Authentication Mode is set as
encryption type can be TKIP or AES.
WDS WPA/WPA2 Pre-Shared Key:
authentication mode is set as WPA Personal or WPA2 Personal.
WDS MAC List: Specify the destination MAC address device. The MAC addresses filter
tunneling lets you select exactly which stations should have access to your network.
[Wireless AP List]
When you configure WDS setting, you must click "Refresh AP List" button first to search
nearby AP router.
[Example for configuring two Wireless AP Routers by WDS function]
Before you setup two wireless AP routers into WDS settings, you must do the follow
requirement:
(1) Two AP router's LAN IP address must be different, for example:
192.168.1.1 and B AP router is 192.168.1.2.
(2) Second AP router (client router)'s DHCP must be disabled.
(3) Both of AP router's WDS function must enable.
(4) A AP router's Wireless MAC address section must enter
address; by the same token,
AP router's Wireless MAC address.
(5) Both of AP routers' Authentication mode must be same.
(6) Both of AP routers' Channels must be same.
Attention: Following setting steps must be set up for both of AP router.
Step 1: Go to Network Settings
192.168.1.1 and B AP Router's LAN IP address as 192.168.1.2. Click "Submit" to save the
WPA Personal
Specify the pre-shared key to secure WDS, if your
B AP router's Wireless MAC address section must enter
LAN section, setup A AP
WEP Auto; WEP is the only
or WPA2 Personal, the WDS
A AP router
B AP router's Wireless MAC
Router's LAN IP address as
is
A
52