Mounting Locations (Chassis) - SSANGYONG Korando 2010 Manual

01-2
0000-00

1. MOUNTING LOCATIONS (CHASSIS)

HECU for ABS
Motor
HU
(Hydraulic
Unit)
The HECU (Hydraulic & Electronic Control Unit) determines the slip conditions of vehicle
wheels by calculating each wheel's speed and the increment/decrement of speed based on the
information detected by the sensors, and controls the pumping and boosting/reducing/keeping
pressure by operating the valve and motor of HECU.
EPS unit
Connector to vehicle (8P)
Motor angle
(8P)
Motor power (3P)
The ECU controls the electric power
steering system depending on the driving
conditions, based on the signals from the
torque and angle sensor.
Fuse for vehicle with EPS
The vehicle with EPS has EPS fuse (80A)
mounted to the positive (+) terminal of the
battery not in the fuse box.
CHASSIS GENERAL INFORMATION
korando 2010.10
HECU (Hydraulic & Electronic Control Unit)
ECU
(Electronic
Control Unit)
Battery (2P)
Torque angle
sensor (8P)
HECU for EPS
Motor
HU
(Hydraulic
Unit)
Steering wheel angle sensor (SWAS)
The steering wheel angle
sensor is mounted between
the steering column and the
steering column shaft. It is
commonly used by the ESP
(Electronic Stability Program)
system. And it receives
signals of the steering wheel
angle sensor from the ESP
HECU (Hydraulic & Electronic
Control Unit).
ECU (Electronic
Control Unit)