Invacare Aquatec Ocean Ergo User Manual page 11

4. Bring the clip mounts C on the front and back of the
side part in line with a hole in the seat frame E.
5. Insert the clips F from the outside into the side part,
until the clip edges G enclose the seat frame tube B.
IMPORTANT
– Ensure that the left and the right side parts are
set to the same height.
6. Turn the seat frame and repeat the procedure on the
second side part.
7. Set the seat frame with the fitted side parts on its
wheels.
Adjusting the seat height
WARNING!
– The seat height must be adjusted to the same
height on both sides.
– Do not adjust the seat height when someone is
sitting on the shower and toilet commode.
1. Raise the shower and toilet commode slightly on one
side by the seat frame B.
2. Remove both clips F on this side.
3. Pull the seat frame out of the side part A or push it
into the side part to adjust the seat height.
4. Push both clips back in completely.
5. Repeat step 1-4 on the other side.
The seat height can be adjusted to accommodate
different situations of use e.g. transfer from a bed
or a wheelchair or use above a toilet etc.
Installing the base stabilization tube (Ocean Ergo XL only)
1639501-B
1. Install the base stabilization tube A using the screws
and nuts B supplied between the side parts C. Make
sure the stabilization tube is facing upwards.
2. Tighten the screws with a torque of 5 Nm.
Setup
11