Chap.5 How To Connect With Wired Lan / Wi-Fi - Kanematsu Corporation TactPlus. User Manual

Opera�on Manual
How to connect with Wi-Fi
* For connec�ng with USB cable, follow the step "ch3 How to connect" .
■limitation of interface
Please connect with one interface from Wired LAN/ Wi-Fi/USB interface.
the printer is not supported mul� interface connec�on.
【caution】
■NOTE for Wi-Fi connection
Normally printer will automa�cally connect through Wi-Fi but
when Wi-Fi is not connected because of radio wave state, (Blue light is not lit)
turn off/on the printer and check Wi-Fi is working properly.(Blue light will be lit)
<Prepara�on>
Install applica�on of USB printer driver(P.10) with USB mode beforehand.
And connect between printer and USB cable.
(1) Open Easytac�x folder,
and click "EasyTac�x Navigator"
(2) Select " Wi-Fi " from the menu.
click
Chap.5
How to connect with Wired LAN/Wi-Fi
(2) int the "HOST " , connectable Wi-Fi host
will be displayed. if it is not appeared
a�er a while, confirm the connec�on with printer
and click "seach" .
click
click