Installation; Commissioning - eKey home KNX RS-485 Operating Instructions Manual

Installation

Mount and wire the product correctly before connecting power.
Possible property damage!
Do not connect the power supply beforehand!
Mount the system in accordance with the supplied mounting instructions.
Wire the system in accordance with the supplied wiring diagram.
The wiring diagram displays the wiring of the ekey home converter KNX
RS-485. Refer to the wiring diagram for the finger scanner for the wiring
of the ekey home finger scanner and the lock.

Commissioning

Extensive specialist knowledge is needed to configure a KNX system.
Commissioning should be carried out by a KNX specialist.
The ekey home converter KNX RS-485 is ready for operation once the
wiring configuration has been carried out and it has been connected to the
power supply.
The KNX LED lights up green. The RS-485 LED flashes green irregularly.
The ETS5 engineering tool software and the required hardware
components are used to configure the ekey home converter KNX RS-485.
The ekey home converter KNX RS-485 is a KNX-certified device and can
be found in the device database of the KNX organization using the ETS5.
ATTENTION
NOTICE
NOTICE
en│7