Streamliner 353
3-wheel Streamliner 353 ONLY (for 4-wheel model wheel assembly, go to page 6)
•
FRONT WHEEL
Tools needed:
two 3/4" wrenches
➊
Locate the parts for front
wheel assembly.
• 1 no-flat tire
• 1 axle bolt and nut
• 1 large wheel spacer
• 1 small wheel spacer
• 2 ½" washers
➋
Thread axle bolt through ½" hole on
the front of the frame that extends ahead of the Hopper.
➌
With the axle bolt through the hole, add the large wheel spacer, followed by a
washer to the axle.
➍
Add the no-flat tire to the axle so the flat side of the tire hub is next to the first
washer (figure 1, right).
➎
Push axle bolt through the tire and add washer, then slide the small
wheel spacer onto the axle bolt (figure 2, right).
➏
Push the axle through the ½" hole on the other side of the frame and attach
the axle nut.
➐
Using a 3/4" wrenches, secure the nut to the axle bolt.
DO NOT OVER TIGHTEN. Make sure the tire rotates freely.
This completes assembly for the 3-wheel Streamliner 353.
4
4
BeaconAthletics.com
A S S E M B L Y
Continue to "Operation" on page 8.
|
800-747-5985
|
Front Wheel
I N S T R U C T I O N S
|
fax 608-836-0724