Making Network Settings; Procedure - FujiFilm NXT Setup Manual

3. Machine Set Up
3.6

Making Network Settings

Before communication is possible with the NXT base, the IP address must be changed to
an appropriate IP address for the factory. If the new IP address is not known, then contact
the network administrator for an appropriate IP address.
The IP address for a base can be changed remotely with ease. It is necessary to know the
current IP address in order to change the IP address to an IP address that is appropriate
for the network. The NXT software tool, NetworkSetting, is used to change the current
network settings for a base.
3.6.1

Procedure

1. Insert the NXT software CD-ROM into the CD-ROM drive and open the drive for the
CD-ROM through Explorer.
2. Double-click [NXT] to open that folder.
3. Double-click NetworkSetting.exe to start the software.
4. When requested, enter the IP address of the base for which to change the network
settings and then click [OK].
Note:
5. Specify the new IP address, subnet mask, and default gateway in the appropriate text
boxes and click [Next].
Note:
6. Specify the host name for the NXT and then enter any domain information if a domain
is used.
7. Click [Next].
8. Specify the preferred and alternate DNS servers in the appropriate textboxes if these
are used.
9. Once all settings have been completed, click [Ok] and the new settings are sent to the
NXT machine.
10.Reboot the NXT machine to enable the new network settings.
40
If the current IP address of the base is unknown, use the information command found in manual mode
on one of the modules attached to the base to display the current IP address for the base.
Even if not changing any of these items, these values must be entered using the current values.
QD002-07
NXT Setup Manual