Table of Contents
Advertisement
QD002-07
2. Setting Up the NXT
2.1 Introduction
The aim of this manual is to provide procedural explanations of how set up the NXT
machine. The procedures outlined are to help an NXT user perform the various
mechanical, and software related operations necessary to set up the NXT for use.
The order of the procedures in this manual are basically in the order that they should be
performed for the easiest set up. In all cases, not all procedures (such as setting the IP
address of the base) need to be performed, especially when just moving the machine/base
within the factory. Refer to the table below for an outline of the setup process.
ter
Making Basic
Connections
Installing Additional Dependent Bases
Connecting an NXT Base to Other
Machine Types
Tray Unit-L
Creating a factory
Creating a line
Creating a machine
NXT Setup Manual
Electric Power
Supply
Adjusting the height
and levelness
2. Setting Up the NXT
Ord.
Step
1
Move the machine to the desired location.
2
Remove the brackets used to fixed the
axes during transport.
3
Connect the power cable to the base.
4
Connect the network cable to the base.
5
Connect the air supply to the base.
6
Level the machine and ensure that the
conveyor height matches that of the other
machines in the line.
7
Specify the IP address and other network
related settings for the set up base.
8*
Connect the communication cables
between the NXT bases.
8*
Connect the communication cables and
the pneumatic tubes between the NXT
bases. Fix the bases with brackets.
8*
Connect the communication cables
between the NXT base and neighboring
machines other than NXT bases.
9
Use a level gauge to adjust the height and
levelness.
10
Create a factory in the Fuji Flexa line
configuration, if necessary.
11
Create a line in the Fuji Flexa line
configuration, if necessary.
12
Create the NXT machine in the desired
line in the Fuji Flexa line configuration.
21
Advertisement
Table of Contents
