Using the finisher
Finishing jobs may originate from copy jobs at the printer or files sent from a computer. This chapter describes
finishing tasks for jobs sent to the printer from a computer and copy jobs initiated from the printer.
Notes:
•
If a finishing option such as Staple, Offset, Hole punch, or Fold is unavailable, select a different bin from the
Output bin menu. To access the menu, click Properties
•
Files printed directly from a flash drive inserted into the USB port on the front of the printer will receive only the
finishing options that are enabled from the Finishing menu. These are the default settings for every print job.
Setting the default paper source
Use the printer menus to specify a default paper source. The printer uses the default source when Automatically
select is chosen from the Print Properties "Paper tray" menu or when a job is initiated from the printer and multiple
trays contain the same paper size and type specified by the job.
1
On the home screen, touch
2
Touch Paper Menu.
3
Touch Default Source.
4
Touch
repeatedly until the correct paper tray appears.
5
Touch Submit.
The settings are updated.
Stapling
Using staple finishing
1
With a document open, click File
2
Select the Paper tab, and then click the Staple button.
Note: If the Staple button is unavailable, select a different output bin from the Output bin menu.
3
Click More Finishing Options.
The Finishing Options dialog appears.
4
Select a staple position, and then click OK repeatedly until the Properties dialog closes.
•
Front—Places the staple through the upper-left corner of the pages
•
Back—Places the staple through the lower-right corner of the pages
•
Dual—Places two staples along the left edge of the pages
The finishing job is sent.
.
Print
Properties.
8
Paper
Output bin menu.