Hookups And Settings; Step 1: Connecting The Aerial Cable - Sony SVR-HDT1000 Operating Instructions Manual

Hookups and Settings

Step 1: Connecting the Aerial Cable

Connect the aerial cable by following the steps below. Do not connect the mains lead until
you have made all the connections.
To watch TV in standby mode, set "Standby Mode" to "Mode 2" in "Step 3: Easy Setup"
(page 13) or use a splitter (not supplied) to divide aerial input signals between the TV and the
recorder.
Wall
to AERIAL IN
: Signal flow
1
Disconnect the aerial cable from your TV, and connect it to AERIAL IN on the rear
panel of the recorder.
2
Connect AERIAL OUT of the recorder to the aerial input of your TV using the supplied
aerial cable.
10
to AERIAL OUT
to aerial input
Aerial cable (supplied)
Hard disk recorder
TV