Sony PJ50V Operating Manual page 62

The battery pack temperature is high. Change

the battery pack or place it in a cool place.
Slow flashing
The temperature of your camcorder is getting

higher. Turn off your camcorder and leave it
in a cool place.
Fast flashing
The temperature of your camcorder is

extremely high. Turn off your camcorder and
leave it in a cool place.
The temperature of your camcorder is low.

Make the camcorder warm.
No memory card is inserted (p. 22).

When the indicator flashes, there is not

enough free space for recording images. Delete
unnecessary images (p. 36), or format the
memory card after storing the images on other
media.
The Image Database File is damaged. Check

the data base file by touching
 [Setup]  [
[Repair Img. DB F.]  the recording medium.
The memory card is damaged. Format the

memory card with your camcorder (p. 57).
Incompatible memory card is inserted (p. 22).


The memory card is write-protected.

Access to the memory card was restricted on

another device.
US

(MENU)
(Media Settings)] 
There is something wrong with the flash.

The amount of light is not sufficient. Use the

flash (HDR-PJ50/PJ50V) .
The camcorder is unsteady. Hold the camcorder

steady with both hands. However, note that
the camera-shake warning indicator does not
disappear.
The drop sensor function is activated. You may

not be able to record nor play back images.
The recording media is full. Delete unnecessary

images ( p. 36 ).
Photos cannot be recorded during processing.

Wait for a while, then record.
When [ REC Mode] is set to [Highest

Quality ] or [60p Quality
capture photos while recording movies.
Furthermore, if [ Frame Rate] is set to [24p]
(HDR-PJ50/PJ50V), you cannot record photos
while the camcorder is in movie recording
standby mode.
], you cannot