Sony PDW-F335KL Operating Instructions Manual page 22

c Viewfinder front-to-back positioning knob
Loosen this knob to adjust the front-to-back position of the
viewfinder (see page 37).
d Lid of the disc compartment
This opens when the EJECT button on the top panel is
pressed. Press the side of the lid to close.
e Accessory fitting shoe
Attach an optional accessory such as a video light (see
page 40).
f Shoulder strap fitting
Attach the supplied shoulder strap (see page 39).
g Viewfinder left-to-right positioning ring
Loosen this ring to adjust the left-to-right position of the
viewfinder (see page 37).
h Viewfinder fitting shoe
Attach the supplied viewfinder.
i Fitting for optional microphone holder
Fit an optional CAC-12 Microphone Holder (see page 41).
j LIGHT (video light) connector (2-pin, female)
A video light with a maximum power consumption of 50
W, such as the Anton Bauer Ultralight 2 or equivalent can
be connected (see page 40).
k MIC IN (microphone input) (+48 V) connector
(XLR type, 5-pin, female)
Connect the supplied stereo microphone to this connector.
The power (+48 V) is supplied via this connector.
l Shoulder pad
Raise the shoulder pad fixing lever to adjust the position in
the front-to-rear direction. Adjust the position for
maximum convenience when operating the unit on your
shoulder.
For details of the adjustment, see "Adjusting the Shoulder
Pad Position" on page 39.
22
Location and Function of Parts
1 Video output and timecode connectors
1 GENLOCK IN connector
GENLOCK
IN
Y
VIDEO
OUT
2 VIDEO OUT Y/P
a GENLOCK IN (genlock signal input) connector
(BNC type)
Input an SD or HD reference signal when applying a
genlock to the camera, or synchronizing timecode to an
external source. Use the GENLOCK page of the
MAINTENANCE menu to carry out phase adjustment of
the horizontal synchronization signal for genlock.
Note
The subcarrier phase cannot be adjusted.
b VIDEO OUT (video output) Y/P
(BNC type)
Output component video signals (Y/P
monitor.
Connect a video monitor with component video signal
input connectors to check the video being shot by the
camera. You can also monitor VDR playback video.
You can select HD Y/P /P
B R
on the OUTPUT page of the OPERATION menu. For
details, see "Selecting the Output Signals" on page 139.
Note
Video signals are not output if the connection destinations
of these connectors are not terminated properly.
P
B
P
R
/P connectors
B R
/P connectors
B R
/P ) for a video
B R
or SD Y/P /P signal output
B R