Assembly Instructions; Operating Instructions - WALLACH ZOOMSTAR User Manual

ASSEMBLY INSTRUCTIONS

The ZoomStar™ with Trulight™ colposcope has three parts.

The Optics with eyepieces

Center Pole with the power control box

The Floor stand
1. Place the floor stand on the floor.
2. Insert the tapered end of the shaft on the bottom of the center pole into the center hole of the
floor stand. Attach the center pole to the floor stand using the tools and hardware supplied
with the floor stand.
3. Place the microscope head into the retaining ring with ocular tubes pointed upwards. Hand-
tighten the thumbscrew. Remove protective caps from the diopter rings. Gently push the
eyepieces into the binocular tubes.

OPERATING INSTRUCTIONS

To operate the ZoomStar with Trulight colposcope:
1. Set it to the height that best suits your position via the two height adjusting controls. The
control that sets the coarse height adjustment is the large knurled hand screw on the Stand
System.
2. Raise the Optics to the desired height and then tighten the hand screw on the stand. The fine
height adjustment is the handle that protrudes at a right angle from the column. Turning this
handle will raise or lower the Optical head, but since this is a fine height adjustment, the
degree of adjustment is limited.
3. Plug the power cord into a standard 115/240 volt receptacle.
4. The master power switch (lighted green rocker switch) is located on the side panel of the
electronics box located on the pole. This switch turns the main power source ON ("I")
or OFF ("O").
5. The black switch on the side panel turns on the white light or the green light. The black
Illumination knob on the front panel adjusts the viewing light intensity.
6. Adjust the tilt position of the head using the tilt handle which protrudes from the side of the fine
focus rack.
IMSC036-DFU • Rev. B • 10/14 4 Made in the USA