Motor Settings - New Position - PEGASUSASTRO FocusCube Operating Manual

•
Press "Connect" button
•
Application will connect to the controller and the "Connected" status will appear on the bottom taskbar.
Led status
You can operate the led indicator on the top of controller on demand. Click the circle "LED" icon and switch on or off the LED of
the controller.
Motor Settings – Max Speed
All stepper motors have limits of the max speed they can achieve. If you set "max speed" faster than your motor can support, it
will probably jump / loose steps and make weird noises as it cannot keep up with the controller's designated steps.
How to connect max speed:
•
Connect to the controller
•
Go to settings and check "Motor Settings"
•
Set steppers motor "Max Speed" and click "Set". Setting will be stored to controller's memory (EEPROM)
•
Power cycle controller to verify new setting and apply max step speed.
WE STRONGLY SUGGEST TO LEAVE THE MAX SPEED TO DEFAULT SETTINGS

Motor Settings - New Position

If you need to change the current position of the controller, you can do it through this option.
• Type new position and press "Set" Button
•
Controller will instantly set new position the value you specified.
Notice that controller will not move motor. Controller will only change value of reported current position
This feature is very useful when you need to zero the position of the focuser or set another value.
You can also zero the position of the focuser by clicking the "000" button in the top taskbar of the application.
AS IT IS OPTIMIZED FOR THE PEGASUS MOTOR
PEGASUS ASTRO - FOCUSCUBE | v1.1
9