Table of Contents
Advertisement
Temperature Sensor Socket
The probe is an external temperature measurement device which is attached to the controller. It comes with length of 1m cable.
Probe measures temperatures from -55°C to +125°C.
Accuracy of the probe is ±0.5°C from -10°C to +85°C. The controller detects the presence of the probe and requests temperature
readings at 30 sec intervals. When using multiple controllers and probes, the reported temperature may differ slightly between
units due to small differences between individual sensor readouts.
This does not affect the operation of the units, as they respond to measured temperature change, not to the actual temperature.
Please notice that you have to connect the sensor before you power on the controller. If you connect it later you
will have to wait for 30 sec for probe recalibration.
Auxiliary Connector
The controller is fitted with a RJ45 Female Jack for auxiliary usage. In this socket you can only
connect the optional Hand Controller.
DO NOT CONECT ANY MOTOR OUTPUT OF AN EXTERNAL CONTROLLER SUCH AS ULTIMATE POWERBOX
OR DUAL MOTOR FOCUS INTO THE RJ45 PORT. THIS WILL CAUSE DAMAGE TO THE DEVICE!
IMPORTANT NOTICE:
PEGASUS ASTRO - FOCUSCUBE
| v1.1
3
Advertisement
Table of Contents
