Danfoss MCB140 Original Operating Instructions page 23

Parameter description - Group P3
No. Name
P 301 SS1 Delay time
P 302 Zero Speed Limit
P 303 SLS Speed Limit
P 304 SMS Speed Limit
Table 24: Parameter group 3
The parameters P302..P304 are only effective if speed detection is enabled (P201 > 0)
Parameter description - Group STORE (Parameter group 4)
Readout Memory options
YES
StorE No
dEFAULt
Table 25: Parameter group STORE
Overview of input terminal configurations
The following references and signal types are defined:
Mnemonic Schematic diagram
NC-NC
NC-NO
OSSD
PNP-NPN
NO-NO
NC-noP
NO-noP
Table 26: Definitions of input switch states which can be set
Safety technology: MCB14x
Setting value
0....7200s
6 ...1350 RPM
Zero Speed + 10%
SMS Speed – 10%
SLS Speed + 10%
15000 RPM
Default Notes
Changes are saved
Yes Changes are discarded
All parameters are reset to their default values
Pout_1 SS1_1 (SLS_1, Door_1)
Pout_2 SS1_2 (SLS_2, Door_2)
+24V SS1_1 (SLS_1, Door_1)
+24V SS1_2 (SLS_2, Door_2)

Intr insically SS1_1 (SLS_1, Door_1)
saf 
e
outputs PNP SS1_2 (SLS_2, Door_2)

SS1_1 (SLS_1, Door_1)
Intr insically
saf 
e
SS1_2 (SLS_2, Door_2)
outputs XOR
Pout_1 SLS_1
Pout_2 SLS_2
+24V SS1_1 (SLS_1, Door_1)
+24V SS1_2 (SLS_2, Door_2)
+24V SLS_1
+24V SLS_2
Document No.: MG34Y104
Default Notes
Trip delay delay of O23...O33 outputs
5
once SS1 is enabled
60 Upper speed limit for standstill
Upper speed limit for operating mode 2
1500
Upper speed limit for operating mode 1
12000
Notes
Test cycles of Pout_1/2 outputs must be used
Signal antivalence as criterion for short circuit
or crossover
Short circuit and crossover test carried out by
signal reference outputs
Short circuit and crossover test carried out by
signal reference outputs
Test cycles of Pout_1/2 outputs must be used
Short circuit and crossover test of MCB
disabled
Short circuit and crossover test of MCB
disabled
Rev.: 06 23 October 2012 Page 23 of 25