Table of Contents
Advertisement
Parameterisation Level 3: Parameter setting
PLUS or MINUS key to set the desired value
n
c
-
n
c
then: ENTER key for temporary storage and back to Level 2 (Parameter selection)
n
c
-
n
o
or:
MINUS key to go back to Level 1 (group selection/storage/termination)
P
1
_
_
Storage of configuration in Parameterisation Level 1
PLUS key to select "Storage" group
P
1
_
_
then: ENTER key to confirm storage option selection
Y
E
S
then: PLUS key to select the desired storage option
Y
E
S
then: 2. Press ENTER to run the selected storage option
...Placeholder
Once stored, the updated checksum is read out for 2s, then the configuration is automatically terminated and the
monitoring operation along with status readout is enabled once again.
c
r
c
*
*
Notes on operation and configuration menu readout
Restoring the settings as shipped or resetting any unwarranted changes is only possible using the overall
configuration feature.
Any changes to the configuration must be explicitly saved before exiting the menu.
If no keys are pressed for 1 min or more when in the enabled configuration menu, then the menu is automatically
terminated. Any new settings made are then lost.
The parameters can be set in any order. No parameters will disappear.
Speed settings are also possible, even if speed detection is not parameterised.
In order to ensure the condition zero speed < SLS speed < SMS speed, then any changes to one of these
parameters will see the limit values and feedback of the other dependent parameters be automatically checked
and,
where necessary, automatically adjusted.
For control purposes, the current 8-bit-checksum (crc**) of all parameters is read out for approx. 2 s
when entering and exiting the configuration menu. A comparison of values confirms the effectiveness of
the changes
made.
Safety technology: MCB14x
n
c
-
n
o
P
1
0
1
P
2
_
_
n
o
*
*
*
Document No.: MG34Y104
o
s
s
d
P
3
_
_
d
E
F
A
U
Rev.: 06
23 October 2012
S
t
o
r
E
Page 21 of 25
Advertisement
Table of Contents
