Safety Information; Safety Precautions; Installation; Connecting Power - OHAUS SF40A User Manual

1. SAFETY INFORMATION

Definition of Signal Warnings and Symbols
WARNING For a hazardous situation with medium risk, possibly resulting in injuries or death if not avoided.
CAUTION For a hazardous situation with low risk, resulting in damage to the device or the property or in loss
of data, or injuries if not avoided.
Attention For important information about the product.
Note For useful information about the product.
Warning Symbols
General hazard

Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain all
instructions for future reference.

Verify that the local AC power supply voltage is within the input voltage range printed on the AC adapter's ratings label.

Only connect the AC adapter to a compatible grounded socket.

Position the instrument such that the AC adapter can be easily disconnected from the socket.

Position the power cord so that it does not pose a potential obstacle or tripping hazard.

Operate the equipment only under ambient conditions specified in the user instructions.

Do not operate the equipment in hazardous or explosive environments.

Disconnect the equipment from mains power before cleaning or servicing.

Service should only be performed by authorized personnel.
Intended Use
Use the instrument exclusively for printing as described in the operating instructions. Any other type of use and operation
beyond the limits of technical specifications without written consent from OHAUS, is considered as not intended.
This instrument complies with current industry standards and the recognized safety regulations; however, it can constitute a
hazard in use.
If the instrument is not used according to these operating instructions, the intended protection of the instrument may be
compromised and OHAUS assumes no liability.

2. INSTALLATION

2.1 Connecting Power

AC Adapter Installation
Connect the AC adapter power cord to the instrument's power input connector, and then connect the AC plug to a suitable
electrical outlet.
Attention: Only use an AC adapter specified by OHAUS.
2.2 Connecting the printer to the instrument
Before connecting, make sure the instrument and printer have the same RS232 parameter setting. For instrument Baud rate
settings, please see the related manual.

Attach the interconnect cable to the printer interface of the instrument and to the printer.

Switch the instrument on

2.3 Switching the printer on

.

Connect the printer to the mains power as described in section 2.1.

Use the main switch <I/O> to power on.

RS232 interface only: The pilot lamp will flash until an instrument is
connected.
<I/O>
Pilot lamp
Electrical shock
EN-1