Maintenance; Troubleshooting; Technical Data; Pollution Degree - OHAUS SF40A User Manual

EN-4
3.3 Using the Instrument
Weiging application:
1. If required, place an empty container on the pan and press Tare.
2. Add sample to the pan or container. The display shows the weight of the sample.

4. MAINTENANCE

4.1 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.

4.2 Troubleshooting

For technical issues contact an Authorized OHAUS Service Agent. Please visit our website www.OHAUS.com to locate the
OHAUS office nearest you.

5. TECHNICAL DATA

The technical data is valid under the following conditions:

Indoor use only.

Operating temperature: 0° C to 40° C.

Relative humidity: maximum relative humidity 80 % for temperatures up to 31 ° C, decreasing linearly to 50 % relative
humidity at 40 ° C, noncondensing .

Altitude: Up to 2000 m.

Power input: 100-240 VAC, 1 A, 50/60 Hz", 12 VDC, 2.5 A

Mains supply voltage fluctuations: up to ± 10% of the nominal voltage.


Pollution degree: 2

Specifications:
Power supply
Power line voltage
Power consumption
6. COMPLIANCE
Compliance to the following standards is indicated by the corresponding mark on the product.
This product complies with the EU Directive 2002/96/EC (WEEE). Please dispose of this product in
accordance with local regulations at the collecting point specified for electrical and electronic equipment.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
.
AC/DC adapter: 12 VDC, 2.5 A
Primary: 100 – 240 VAC, -50 -60 Hz
Voltage fluctuations:
up to ± 10% of the nominal voltage
Secondary: 12 VDC, 2.5 A
(with electronic overload protection)
12 VDC
Max. 2.5 A