DMX Loss Behavior
The DMX Loss Behaviour menu allows you to set the behavior of the dimmers when data
communication is lost.
DMX Loss Behaviour
Mode:
Wait:
Fade:
M o d e
In the "Mode" menu option, select the loss behavior as follows:
Step 1:
Step 2:
Step 3:
W a i t
When "Wait and Fade" is selected, this menu option allows you to set the time span for
holding the dimmer levels before fading. To change the wait time:
Step 1:
Step 2:
Step 3:
F a d e
When "Wait and Fade" is selected, this menu option allows you to set the time span over
which the dimmers fade to zero. To change the fade time:
Step 1:
Step 2:
Step 3:
When finished, press the
(<<) button to return to the Home screen.
[Home]
Menu structure
Hold Last Look
0 min 3 sec
0 min 3 sec
Press the [Enter] (
Use the [Increase] (+) or [Decrease] (–) button to highlight the desired loss
behavior:
• Hold Last Look – Holds the active dimmers at whatever levels they were
receiving when the data was lost. The dimmers remain on until either data
is restored or the cabinet is reset.
• Wait and Fade – Holds active dimmers for a span of time, at whatever levels
they were receiving when the data was lost, and then fades those dimmers
to zero in a defined fade time. You can define both the wait time and the
fade time, within a maximum of 59min:59sec.
Press the [Enter] (
Press the [Enter] (
Use the [Increase] (+) or [Decrease] (–) button to set the minutes value, and
then press the [Enter] (
Press the [Enter] (
Press the [Enter] (
Use the [Increase] (+) or [Decrease] (–) button to set the minutes value, and
then press the [Enter] (
Press the [Enter] (
(<) button to return to the previous menu, or press the
[Back]
) button.
) button.
) button.
) button. Repeat for the seconds value.
) button.
) button.
) button. Repeat for the seconds value.
) button.
13