CD-200-SET Installation Guide General: The CD-200-SET system is an access control system for private houses. The system includes an entrance encoder "CD-200" and a telephone line adapter unit. The system enables speaking with visitor who is waiting at the door or the entrance gate, using any telephone in the house including wireless.
Page 3
Even if you use the socket, you can still draw voltage from the 12VAC terminals. 3. PANEL1 – pair of wires from the LINE terminals of the CD-200 encoder located near the main door. 4. DOOR1 – control over the main door’s lock. Pair of wires from REX terminals of the CD-200 encoder located near the main door.
Page 4
When no conversation – turned off. Microphone and speaker volume adjustments The CD-200 unit leaves the manufacturer site adjusted. Sometimes because of the location (opened or closed space), acoustical problems occur. If the panel’s speaker sound level is too high or low, gently rotate the panel’s internal SP potentiometer.
Page 5
Turn off the power and move the jumper to 2 pins below. Reinstall the panel. The CD-200 returns to normal condition. The Programming code now is: 123456 *. Canceling an access code A particular access code could be cancel if its memory cell location is known.
Page 6
CD-200-SET Installation Guide now the following sequence should be entered: memory cell number to cancel(2 digits), and confirm with *. ֠ ֠ ֠ ֠ ֠ ֠ ֠ ֠ For example: canceling the code stored in cell number 01: press the following sequence: ⇒123456 *, 01 *.
CD-200-SET Installation Guide Operation Calling at the door Press the Bell . A short tune will be sound, wait for vocal answer. If authorized, the lock will ֠ ֠ ֠ ֠ buzz for 3 seconds, and you may enter. Opening the lock using the keyboard Enter the access code confirm with *.