Related Manuals for Tador KX-T927-MTL-Rfid
Summary of Contents for Tador KX-T927-MTL-Rfid
- Page 1 33311 Doorphone Door Access Communicator Instruction Manual KX-T927 KX-T927-MTL KX-T927-MTL-Rfid Please read this manual carefully before using the product.
-
Page 2: Parts And Functions
Microphone Screws 2. General Tador Doorphone The Doorphone unit is an intelligent telephone connected to telephone exchange, mounted on office entrance and enables visitors to call to a predefined extension. Person receiving a call from the door panel can speak with the visitor and open the door from his telephone extension by pressing a particular key. -
Page 3: Before Installation
3. Two wires from a telephone exchange free extension. 4. 2 wires from optional bypass pushbutton (if installed). Assemble the wires through the hole on the back box of Tador Doorphone. Mark the four drill points of the back box on the wall. -
Page 4: Programming Speed Dial Numbers
10 seconds. Programming speed dial numbers There are 10 cells in Tador Doorphone memory to store 10 speed dial numbers. Cells 41 to 49 are used for speed dial 0 to 9 keys respectively (cell 41 – 1, 42-2…). Cell 50 is used to speed dial the 0 key or bell ( ) -
Page 5: Number Of Rings To Answer
Number of Rings to Answer – This programming section sets the number of rings that the Tador Doorphone will allow to pass through the system before it picks up the call. Cell number 12, (default one ring). Example: Change the number of ring to answer to 3 rings. - Page 6 Camera relay strike – Set the camera relay strike time (play time, default 30 sec). Example: change the camera uptime to 40 seconds. Enter remote programming mode, Enter cell number 14, followed by the new value you want to set 40(two digits), and then press Hash (#) key to approve. Programming code programming Cell number...
- Page 7 5555 11.1. Add RFID card follow the below instruction: a. Dial from any telephone to the extension of Tador Codephone. b. Press the hash key twice (#, #) (the keypad will blink to confirm programming mode active). c. Press 88# to enable RFID card programming d.
- Page 8 For erasing/replacing RFID card you have know the memory sell number where card have been stored a. Dial from any telephone to the extension of Tador Codephone. b. Press the hash key twice (#, #) (the keypad will blink to confirm programming mode active).
- Page 9 Initiating Tador Doorphone – Clear all memory In order to reset the Tador Doorphone from all its memory including speeds dial access codes and restore all settings to default values. Follow these steps: 1. Disconnect the power supply from the Doorphone.
- Page 10 Drawing Volume Volume For programming and restore move the jumper up For restoring device add PROXY jumper on PRG Call buton Board Remove the jumper after restore completion Button Connector RELAY -12V+ Remote LINE Telephone extation 12AC Electric lock Bypass pushbutton...
- Page 12 Thank you for choosing our products www.Tador.com All rights reserved to Tador Technologies LTD©...