General:
The 5 wires panel is an intercom system, serves as a door panel.
The main advantage of the system is that the panel doesn't require a
special design handset for the system and can work with any standard 5
wires handset.
With this unit you can speak with the visitor who is waiting at
the door and open the electric lock from the intercom handset .
An optional bypass pushbutton enables easy internal
opening (the opening time is programmable)
Features:
Easy installation, programming and
operating.
Surface and flush mount installation available
Specifications:
Operating voltage: AC 12V 800mA
Operating electric or magnetic lock. (normally
open)
Color: silver or bronze
Installing The DR-500 Panel:
Install the lock in the door frame.
Using a Phillips screwdriver open the top cover, carefully pull up the panel.
Using a screw driver, expose the 4 covered insulations bores and the round wirings bore.
Attach the base of the Intercom Encoder to the wall, using a pencil mark the 4 fixing points.
Drill the 4 fixing points on the wall.
Route the wires through the round bore in the base of the Intercom Encoder.
Using 4 screws install the base to the wall.
Handset wiring
Several common handsets could be assembled.
Electric buzzer handset can not be assembled, Only electromagnetic
Wiring of different handsets is detailed in the electrical drawing in page 4 and the following
table:
Wire
URMET
COM
6
lock
9
Second
buzzer
buzzer
connection
speaker
1
microphone
2
DR-500 Installation guide
optional bypass exit pushbutton
Environmental and anti vandal resistance.
Opening time: 1-9 seconds
Size: under plaster195X115X50mm (H*W*D)
On the wall 154X100X35mm (H*W*D)
Videx
Audio
handset
Interphone
SMART 1P
3 / 7
6
5
9
6
BZ
1
1
2
2
1
Surface
Mount
Amplyvox
handset
0
Z
1
T
R
Flush/Surface
Mount